Abstract: The wind power is the fastest growing electricity resource in recent world. The incorporation of wind power with grid affects dynamic strategy of entire power system. An abnormal change in wind power is obtained by gradual motion of wind in atmosphere. Demand of reliable, quality power and increasing non-linear load is key factor for awareness of power quality in between utility and customer. Inclusion of wind power with electric grid is the major issue for various power quality problems such as reactive power, sag, swell in voltage magnitude and phase, harmonics and frequency changes. IEC 61400 specified standard guide lines and norms are followed in manufacturing of wind turbine on the basis of power quality. This issue is over come by installation of FACTS devices at point of common coupling. In this proposed scheme D-STATCOM based FACTS devices installed at PCC. To reduce the effect of various power quality issues D-STATCOM is used for providing shunt compensation. It can provide better support for various power quality problems. The performance of devices can be executed by MATLAB/SIMULINK. To enhance the performance of devices conventional PID is used with D-STATCOM. Implementing conventional controller with custom power device, increases the response of generation of compensation signal by its fine tuning of gain factor. By this PID D-STATCOM, the compensation time will considerably decrease which further lead to faster response.