References

Dewangan, S., S. Gangopadhyay and C.K. Biswas, 2015. Study of surface integrity and dimensional accuracy in EDM using Fuzzy TOPSIS and sensitivity analysis. Meas., 63: 364-376.
Direct Link  |  

Fukuzawa, Y., N. Mohri, H. Gotoh and T.A.N.I. Takayuki, 2009. Three-dimensional machining of insulating ceramics materials with electrical discharge machining. Trans. Nonferrous Met. Soc. China, 19: 150-156.
CrossRef  |  Direct Link  |  

Han, F., J. Zhang and I. Soichiro, 2007. Corner error simulation of rough cutting in wire EDM. Precis. Eng., 31: 331-336.
Direct Link  |  

Khaja, M., R. Kumar and V. Singh, 2015. Modeling and optimization of WEDM process parameters on machining of AISI D2 steel using Response Surface Methodology (RSM). Intl. J. Adv. Res. Eng. Sci. Technol., 2: 49-53.

Lee, S.H. and X. Li, 2003. Study of the surface integrity of the machined workpiece in the EDM of tungsten carbide. J. Mater. Process. Technol., 139: 315-321.
CrossRef  |  

Pandey, A. and S. Singh, 2010. Current research trends in variants of electrical discharge machining: A review. Intl. J. Eng. Sci. Technol., 2: 2172-2191.
Direct Link  |  

Phadke, M.S., 1995. Quality Engineering using Robust Design. Prentice Hall, Upper Saddle River, New Jersey, USA.,.

Rao, G.K.M., S. Satyanarayana and M. Praveen, 2008. Influence of machining parameters on electric discharge machining of maraging steels: An experimental investigation. Proceedings of the World Congress on Engineering (WCE’08) Vol. 2, July 2-4, 2008, Imperial College London, London, England, UK., ISBN:978-988-17012-3-7, pp: 1-6.

Satheesh, J., T. Pasha, Harish and T. Madhusudhan, 2013. Optimal machining conditions for turning of AlSiC metal matrix composites using ANOVA. Intl. J. Innovative Res. Sci. Eng. Technol., 2: 6171-6176.
Direct Link  |  

Shrivastava, S.M. and A.K. Sarathe, 2014. Influence of process parameters and electrode shape configuration on material removal rate, surface roughness and electrode wear in die sinking EDM. Intl. J. Emerging Technol. Adv. Eng., 4: 138-145.
Direct Link  |  

Singh, J. and V. Kumar, 2012. Investigation on the material removal mechanism and the thermal aspects in the electrical discharge machining process. Intl. J. Eng. Technol., 2: 1503-1507.
Direct Link  |  

Vishwakarma, M., V. Parashar and V.K. Khare, 2012. Advancement in electric discharge machining on metal matrix composite materials in recent: A review. Intl. J. Sci. Res. Publ., 2: 86-93.
Direct Link  |  

Yan, M.T. and H.T. Chien, 2007. Monitoring and control of the micro wire-EDM process. Intl. J. Mach. Tools Manuf., 47: 148-157.
Direct Link  |