Journal of Engineering and Applied Sciences
Year:
2019
Volume:
14
Issue:
1 SI
Page No.
3850 - 3852
Design and CFD Analysis of Screw Compressor by using ANSYS Software
Authors :
S.Muraliraj
References
Bonaiuti, D., A. Arnone, M. Ermini and L. Baldassarre, 2002. Analysis and optimization of transonic centrifugal compressor impellers using the design of experiments technique. Proceedings of the 2002 ASME Turbo Expo on Power for Land, Sea and Air Vol. 5, June 3-6, 2002, ASME, New York, USA., ISBN:0-7918-3610-X, pp: 1089-1098.
Jang, S.M., H.W. Cho and S.K. Choi, 2007. Design and analysis of a high-speed brushless DC motor for centrifugal compressor. IEEE. Trans. Magn., 43: 2573-2575.
CrossRef | Direct Link | Merchant, A.A., 1999. Design and analysis of axial aspirated compressor stages. Ph.D Thesis, Massachusetts Institute of Technology, Cambridge, Massachusetts.
Merchant, A.A., M. Drela, J.L. Kerrebrock, J.J. Adamczyk and M. Celestina, 2000. Aerodynamic design and analysis of a high pressure ratio aspirated compressor stage. Proceedings of the 2000 ASME Turbo Expo on Power for Land, Sea and Air Vol. 1, May 8-11, 2000, ASME, Munich, Germany, ISBN:978-0-7918-7854-5, pp: 1-10.
Selvakumar, V. and N. Manoharan, 2014. Mechanical and morphological properties of PP/MWNT/MMT hybrid nanocomposites. Intl. J. Eng. Technol., 6: 2351-2356.
Tsai, N.C. and C.W. Chiang, 2010. Design and analysis of magnetically-drive actuator applied for linear compressor. Mechatronics, 20: 596-603.
Direct Link |