References

Barahtenko, E.A., 2010. [Minimizing the warping of thin-walled aircraft parts based on the discrete simulation]. Ph.D. Thesis, Irkutsk Technical University, Irkutsk, (In Albanian).

Cheveleva, A.O. and N.D. Pronichev, 2013. [Improvement of GTE small-rigidity rings control efficiency according to their information models]. Izvestija Samarskogo Nauchnogo Centra RAN., 15: 1004-1008.

Cheveleva, A.O. and N.D. Pronichev, 2014. [Analysis of mathematical model accuracy for estimating the equivalent diameter of GTE compressor stator rings]. Materialy Mezhdunarodnoj Nauchno-Tehnicheskoj Konferencii Samara, SSAU., 2: 73-75.

Falaleev, S. and A. Vinogradov, 2014. Concept of combined gas-dynamic mechanical seal and discharge device of aircraft engine rotor support. ARPN J. Eng. Applied Sci., 9: 1842-1848.
Direct Link  |  

Lastovskij, P.N., 2010. [Ensuring the specified accuracy requirements for automated machining of thin-walled parts]. Ph.D. Thesis, Omsk State University, (In Albanian).

Shabliy, L.S. and I.B. Dmitrieva, 2006. Conversion of the blade geometrical data from points cloud to the parametric format for optimization problems. ARPN J. Eng. Applied Sci., 9: 1849-1853.
Direct Link  |